150mA CMOS High Performance LDO Regulator The KIC3210T series Low Dropout Linear Regulator is ideally suited for portable applications. It offers 1% initial accuracy, extremely-low dropout voltage(135mV at 150mA) and low ground current (typically 90uA). [Read more…]

The OPA727 and OPA728 series op amps use a state-of-the-art 12V analog CMOS process and e-trim, a package-level trim, offering outstanding dc precision and ac performance. The extremely low offset (150µV max) and drift (1.5µV/°C) are achieved by trimming the IC digitally after packaging to avoid the shift in... [Read more…]

The ISL21009 FGA™ voltage references are extremely low power, high precision, and low noise voltage references fabricated on Intersil’s proprietary Floating Gate Analog technology. The ISL21009 features very low noise (4μVP-P for 0.1Hz to 10Hz), low of operating current (180μA, Max), and 3ppm/°C of temperature drift. In addition, the ISL21009 family features guaranteed initial accuracy as low as ±0.5mV.  [Read more…]

The ISL21009 FGA™ voltage references are extremely low power, high precision, and low noise voltage references fabricated on Intersil’s proprietary Floating Gate Analog technology. The ISL21009 features very low noise (4μVP-P for 0.1Hz to 10Hz), low of operating current (180μA, Max), and 3ppm/°C of temperature drift. In addition, the ISL21009 family features guaranteed initial accuracy as low as ±0.5mV.  [Read more…]

Media Contact Gayle Bullock National Semiconductor (408) 721-2033 gayle. [Read more…]

New Page 3Winbond Electronics Corp. recently introduced a new ISP (Image Signal Processor) chip designed to support 3 mega pixel CMOS sensor for high-end camera phones. [Read more…]

The ADR130 is the industry's first family of tiny, micropower, low voltage, high precision voltage references. Featuring 0.35% initial accuracy and 25 ppm/°C of temperature drift in the tiny TSOT-23 package, the ADR130 voltage reference only requires 80 A for typical operation. [Read more…]

The AD9389A-BBCZ is an 80 MHz, high definition multimedia interface (HDMI) v.1.2a transmitter. It supports HDTV formats up to 720p/1080i, and computer graphic resolutions up to XGA (1024 768 @ 75 Hz). [Read more…]

San Jose, CA, November 1st, 2006 . . . Atmel® Corporation (Nasdaq: ATML) announced today three new 20-pin tinyAVR® Flash microcontroller devices with high-speed timers targeting battery chargers, sensor end-points and motor control applications. [Read more…]

The bq24080 and bq24081 are highly integrated and flexible Li-Ion linear charge devices targeted at space-limited charger applications. They offer an integrated power FET and current sensor, high-accuracy current and voltage regulation, charge status, and charge termination, in a single monolithic device. An external resistor... [Read more…]

This 25-bit 1:1 or 14-bit 1:2 configurable registered buffer is designed for 1.7-V to 1.9-V VCC operation. In the 1:1 pinout configuration, only one device per DIMM is required to drive nine SDRAM loads. In the 1:2 pinout configuration, two devices per DIMM are required to drive 18 SDRAM loads.All inputs are SSTL_18, except... [Read more…]

FeaturesLow Start-Up Current... [Read more…]

FeaturesLow Start-Up Current... [Read more…]

FeaturesLow Start-Up Current... [Read more…]

FeaturesLow Start-Up Current... [Read more…]

FeaturesLow Start-Up Current... [Read more…]

NCP5602 and NCP5612 charge pump white LED drivers feature programmable dimming, achieve 87 percent peak efficiency and deliver consistent brightness for handheld and consumer applications CPS Expo 2006– Shanghi, China - Nov. [Read more…]

Capable of delivering 1.3 watts of continuous average power, the NCP2892 and NCP2990 provide high quality audio and minimal power consumption CPS Expo 2006 – Shanghi, China – Nov. [Read more…]

FeaturesSimple Voltage Conversion, IncludingNegative ConverterVoltage DoublerWide Operating Range. . .1.5 V to 10 VRequires Only Two External (Noncritical) CapacitorsNo External Diode Over Full Temperature and Voltage RangeTypical Open-Circuit Voltage Conversion Efficiency. [Read more…]

Features400-MSPS Update RateControlled BaselineOne AssemblyOne Test SiteOne Fabrication SiteExtended Temperature Performance of -55°C to 125°CEnhanced Diminishing Manufacturing Sources (DMS) SupportEnhanced Product-Change NotificationLVDS-Compatible Input InterfaceSpurious-Free Dynamic Range (SFDR)... [Read more…]

The AD9254 is a monolithic, single 1.8 V supply, 14-bit, 150 MSPS analog-to-digital converter (ADC), featuring a high performance sample-and-hold amplifier (SHA) and on-chip voltage reference. [Read more…]

The AD7951 is a 14-bit, charge redistribution, successive approximation register (SAR) architecture analog-to-digital converter (ADC) fabricated on Analog Devices, Inc.'s iCMOS high voltage process. [Read more…]

The AD7610 is a 16-bit charge redistribution successive approximation register (SAR), architecture analog-to-digital converter (ADC) fabricated on Analog Devices, Inc.'s iCMOS high voltage process. [Read more…]

Hittite Microwave Corporation, the world class supplier of complete MMIC based solutions for communication & military markets, has introduced two new SMT packaged GaAs PHEMT MMIC Low Noise Amplifiers (LNAs) which are ideal for Test Equipment, Microwave Radio, Industrial/Medical, Military and Space applications from 6 to 20 GHz. [Read more…]

The AD8189 (G = 2) is a high speed, single-supply, triple 2-to-1 multiplexer. It offers -3 dB small signal bandwidth of 350 MHz and -3 dB large signal bandwidth of 300 MHz, along with a slew rate in excess of 1000 V/µs. [Read more…]